Case for Trump card clone

[Dave]

If this is the one on Thingiverse, I designed it. Everyone is welcome to use it and modify it any way they see fit.

[Derek_Stewart]

If this is the one on Thingiverse, I designed it. Everyone is welcome to use it and modify it any way they see fit.

I looked on Thing Universe, can not see the case you are tslking about, can you supply a link.

[Pr0f]

I vaguely remember seeing one that had a seperate bottom part flat with vents, and through holes in seperate places to allow screwing the top part to it. Does anyone have that design.

I've printed this one on an Ender3Pro - but probably should have done it vertically as the top deformed a little. I was new to 3d printing then

[nikosdoykas]

If this is the one on Thingiverse, I designed it. Everyone is welcome to use it and modify it any way they see fit.

yes found on think giverse and was for rezin printers assume its your dave...

[Dave]

It was designed for printing on either a resin printer, or an Ender 3/5. I included the STLs so people could do as they wished. It is 100% based off the original Sinclair design which Sandy, among others, licensed.

[nikosdoykas]

thank david

[bwinkel67]

Was it this one?

https://www.thingiverse.com/thing:2897118

[Dave]

Yep, that's the one.