Page 1 of 1
Guess what I'm making :)
Posted: Thu Feb 28, 2013 4:53 am
by Dave
I ordered the following today. Can anyone guess what I'm making?
Code: Select all
110 P1.00KFCT-ND RES 1.00K OHM 1/4W 1% 1206 SMD 0 0.028 $ 3.08
165 399-3676-1-ND CAPACITOR TANT .10UF 35V 10% SMD 0 0.1645 $27.14
220 493-1036-ND CAP 10UF 16V ELECT VR RADIAL 0 0.0884 $19.45
55 NJU7660M-ND IC DC/DC VOLTAGE CONVERTER 8-DMP 0 0.95 $52.54
110 478-1903-ND CAP TANT 4.7UF 10V 10% RADIAL 0 0.3168 $34.85
55 WM9132-ND CONN HEADER 4POS .200 VERT 0 0.6578 $36.18
400 ft magnet wire, 38 gauge
Here's a clue: built by TF Services, really useful to have
Re: Guess what I'm making :)
Posted: Thu Feb 28, 2013 9:53 am
by RWAP
Now if it were only a ROMDisq - but looks more like a Minerva - MKII if lucky !!
Re: Guess what I'm making :)
Posted: Thu Feb 28, 2013 11:49 am
by vanpeebles
I was thinking more along the lines of Mechagodzilla?
Re: Guess what I'm making :)
Posted: Thu Feb 28, 2013 1:06 pm
by dilwyn
vanpeebles wrote:I was thinking more along the lines of Mechagodzilla?
if that 400ft of magnetwire is anything to go by ...
Or if Tony's son Ben was anything to go by, Legodzilla
Re: Guess what I'm making :)
Posted: Sat Mar 02, 2013 10:16 pm
by Dave
Nobody's even close yet
Re: Guess what I'm making :)
Posted: Sun Mar 03, 2013 9:57 am
by Mr_Navigator
A battery/generator
Re: Guess what I'm making :)
Posted: Sun Mar 03, 2013 12:57 pm
by dilwyn
QL power supplies for Rich or Mplanes
Re: Guess what I'm making :)
Posted: Sun Mar 03, 2013 3:31 pm
by Dave
MPlanes for the win!
I am completing the remaining stock of MPlane PCBs and Minerva PCBs.
Re: Guess what I'm making :)
Posted: Sun Mar 03, 2013 5:20 pm
by dilwyn
Dave wrote:MPlanes for the win!
I am completing the remaining stock of MPlane PCBs and Minerva PCBs.
So where does the
400 ft magnet wire, 38 gauge come in?
Re: Guess what I'm making :)
Posted: Sun Mar 03, 2013 6:08 pm
by Dave
The Mplane was designed for Auroras and Gold Cards... It therefore omitted a track which is needed if you use an original QL board. Tony used to place this missing track by hiding the wire under the connectors, and I will be doing the same. Magnet wire is perfect - it comes with an insulating coating that protects against shorts, but that works as a flux when soldered.