Page 4 of 4
Re: Case for Trump card clone
Posted: Wed Jan 26, 2022 3:39 pm
by Dave
If this is the one on Thingiverse, I designed it. Everyone is welcome to use it and modify it any way they see fit.
Re: Case for Trump card clone
Posted: Wed Jan 26, 2022 4:57 pm
by Derek_Stewart
Dave wrote:If this is the one on Thingiverse, I designed it. Everyone is welcome to use it and modify it any way they see fit.
I looked on Thing Universe, can not see the case you are tslking about, can you supply a link.
Re: Case for Trump card clone
Posted: Wed Jan 26, 2022 5:00 pm
by Pr0f
I vaguely remember seeing one that had a seperate bottom part flat with vents, and through holes in seperate places to allow screwing the top part to it. Does anyone have that design.
I've printed this one on an Ender3Pro - but probably should have done it vertically as the top deformed a little. I was new to 3d printing then
Re: Case for Trump card clone
Posted: Wed Jan 26, 2022 10:41 pm
by nikosdoykas
Dave wrote:If this is the one on Thingiverse, I designed it. Everyone is welcome to use it and modify it any way they see fit.
yes found on think giverse and was for rezin printers assume its your dave...
Re: Case for Trump card clone
Posted: Wed Jan 26, 2022 11:04 pm
by Dave
It was designed for printing on either a resin printer, or an Ender 3/5. I included the STLs so people could do as they wished. It is 100% based off the original Sinclair design which Sandy, among others, licensed.
Re: Case for Trump card clone
Posted: Thu Jan 27, 2022 11:45 am
by nikosdoykas
thank david
Re: Case for Trump card clone
Posted: Mon Jan 31, 2022 11:56 pm
by bwinkel67
Re: Case for Trump card clone
Posted: Tue Feb 01, 2022 2:26 am
by Dave
Yep, that's the one.