Hi,
The Floppy Disk density commands are:
S = Single Density (360Kb)
D = Double Density (720Kb)
H = High Density (1.44Mb)
E = Extra High Density (3.2Mb) ... only on ED drives with a SuperGold Card
You can use the FLP_DENSITY command to set the floopy disk density, eg
FLP_DENSITY "D"
or
use the FORMAT command to setup the density
FORMAT "FLP1_DISKY1*D"
I found using SMSQ on a QXL, that both had to be setup, I did not use SMSQ/E on the QXL, so hopeful this feature/bug would been fixed.
The screen resolution of QXL is setup in the SMSQ.EXE file using a standard CONFIG blocks, so you have to copy the MSDOS executable to the the QXL side and config it with MENUCONFIG or CONFIG
I used to have one MSDOS executable for each resolution.
Hope this helps.
End of unzip woes?
-
- Font of All Knowledge
- Posts: 4659
- Joined: Mon Dec 20, 2010 11:40 am
- Location: Sunny Runcorn, Cheshire, UK
- qxl-kumbah
- ROM Dongle
- Posts: 24
- Joined: Thu Apr 17, 2014 11:56 pm
- Location: Waltham, MA
Re: End of unzip woes?
Okay, this definitely helps - thank you ! 
I'm still taking notes ... and I should have this "down" soon.
This will definitely give me something to work on ...
Either way, if all goes well with those "disk images", I'll have good news to report.

I'm still taking notes ... and I should have this "down" soon.
This will definitely give me something to work on ...
Either way, if all goes well with those "disk images", I'll have good news to report.

* qxl-kumbah *
"TS-1000, Eighty-One,TS-2068, Spectrum Anywhere, QXL, QLay, and Qemulator on board"
"TS-1000, Eighty-One,TS-2068, Spectrum Anywhere, QXL, QLay, and Qemulator on board"